Why is my reverse light blinking on my 2008 Yamaha Grizzly 450 and what can I do if it is hard to start? Recently noticed that after a few minutes at idle (and still in PARK), that the Reverse light begins to flash. Remove Advertisements.

I have a 07 660 all stock.

I moved it yesterday to be in a better location to change the oil and noticed the reverse light starts blinking after it …
The reverse light is blinking when in park, will not go over 10 miles an hour and chokes out when idling up the - Yamaha 2009 Grizzly 450 Auto 4x4 IRS question I have seen the light blink if you rev it up while just sitting, and when bypassing the diff lock speed limiter. I have a 2006 Rhino 660 and the red reverse light on the dash panel lights solid red when in reverse gear like it it supposed to. What are the possible - Answered by a verified Motorcycle Mechanic. We use cookies to give you the best possible experience on our website. I purchased it used and it was literally ridden hard and put away wet.

My '06 Grizzly is also doing this.

2008 yamaha big bear 400. red reverse light starts blinking after riding just a short time. The blinking reverse light can be normal, im unsure what the point of it was but yamaha has it blink if something seems odd. Why is my reverse light blinking on my 2008 Yamaha Grizzly 450 and what can I do if it is hard to start? Then again it may not be. I also have a sputtering problem while climbing hills.

02 660 electrical question blinking reverse light I have to shut the ignition switch off and restart quad and light goes off. 550 miles on a 2009 450 Grizzly. If so, any chance that the light is flickering slightly when this happens? I'm thinking sticky reverse switch or maybe a short, any suggestions would be welcome.

I just dunked mine about two weeks agao and after that I had a blinking to on all the time reverse light. While driving in forward gear the reverse lights is coming on. Hey there. Also when the reverse light comes on the engine sputters and shuts down. I think this is probably a stupid question, but Ive never noticed it before and I couldnt find anything in the manual.

05 Yamaha Camo Grizzly - 27" Swamp Witches on Type 6 C series - Warn Bumper TorqueWorks is offline Quote Quick Reply. So far I have been able to push the gas pedal to the floor and the light goes out and the engine returns to normal. ... my 2007 yamaha c3 engine light keeps on blinking … I have a 2006 Kodiak 450. Then the reverse light goes out and all is right, speed picks back up and it runs good. It has been stored all winter. Does your reverse light work normally? When I put it in foward gear and start moving foward I will go about 200 feet and the red reverse starts blinking on and off as I drive foward. Yamaha placed the reverse sensor on your dash and it tells the engine control module that you are in reverse.

Then I turned the choke off and let it idle, and the reverse light kept flashing, know what the problem is? Anyone know what this means?
When reverse is engaged the Rhino 660 has a lowered rev-limiter to reduce risk and increase safety when traveling in reverse. I have a 2002 Yamaha Grizzly 660.

Vibration induced by certain RPM's can cause the reverse switch spring connection to break contact briefly, turning the limiter on intermittently - try grounding the wire and see if the problem goes away. I live in Alaska and I think if I can park it in a warm garage for a little while this might just be water in a bad spot.